Malfunction Code Of Outdoor Unit - EAS Electric EVRO-120NDC Installation Manual

4.5 Cooling and heating operation
The indoor unit of the intelligent inverter centralized air
conditioner can be controlled solely, but the indoor unit in the
same system can not run cooling and heating at the same time.
When the Cooling and Heating operation confront with each
other, the Indoor Unit which are running on Cooling Mode would
stop and there will be Standby or No Priority displayed in the
Control Panel. Those Indoor Units which are running on Heating
Mode will run continuously.
If the Air Conditioner Administrator has set running mode,
then the air conditioner can not run on modes other than the
presetted.Standby or No Priority will be displayed in the
Control Panel.
4.6 Features of heating operation
Warm air will not be blown out immediately at the beginning of
the heating operation, 3~5 minutes ago (depends on the indoor
and outdoor temperature), until the indoor heat exchanger
become hot, then blows out warm air.
5

MALFUNCTION CODE OF OUTDOOR UNIT

Table 5-1 (12/14/16KW)
Display
Malfunction or Protection
H0 M_Home unmatching（Reserve）
E0 EEPROM Fault
E2 Communication fault of the outdoor chip and the indoor chip
E3 Communication error between Main board and IR341
E4 Outdoor unit sensor fault
Voltage protection fault
E5
E6 Direct-current fan fault
Heating fan fault in the area A lasts for 5 minutes
E7
E8 There are two times E6 fault in 10 minutes (recovery will be after power off)
P0 The cooling fin high temperature protection
P1 High pressure protection
P2 Low pressure protection
P3 Compressor current protection
P4 Discharge temperature protection
P5 Outdoor condenser high temperature protection
IPM modules protection
P6
Evaporator high temperature protection
P7
P8
Typhoon protection
Display Function Instruction:
1. When stand by, LED displaying the amount of indoor units online which communicate with outdoor units.
2. When operation, LED displaying frequency value of compressor.
3. When defrost, LED displaying "dF".
During operation, the fan motor in the outdoor unit may stop
running under high temperature.
During Fan Operation, if other Indoor Units are running on
Heating Mode, the fan may stop in order to prevent sending
heat wind.
4.7 Defrost in the heating operation
During heating operation, outdoor unit sometimes will frost. To
increase efficiency, the unit will start defrosting automatically
(about 2~10 minutes), and then water will be drained out from
outdoor unit.
During defrosting, both the fan motors in the outdoor unit and
indoor unit will stop running.
33
V.2