Download Print this page

Outdoor Unit Lnstallation; Outdoor Unit Lnstallation Lnstructions - EAS Electric EDM Series Owners And Installation Manual

Duct-type air conditioning
Hide thumbs Also See for EDM Series:

Advertisement

Available languages

Available languages

Outdoor Unit lnstallation

Outdoor Unit lnstallation lnstructions

Step 1: Select installation location.
The outdoor unit should be installed in the
location that meets the following requirements:
1:21 Place the outdoor unit as dose to the indoor
unit as possible.
1:21 Ensure that there is enough room for
installation and maintenance.
1:21 The air inlet and outlet must not be
obstructed or exposed to strong wind.
1:21 Ensure the location of the unit will not be
subject to snowdrifts, accumulation of leaves
or other seasonal debris. lf possible, provi de
an awning for the unit. Ensure the awning
does not obstruct airflow.
1:21 The installation area must be dry and well
ventilated.
1:21 There must be enough room to install the
connecting pipes and cables and to access
them for maintenance.
Fig. 5.1
Step 2: lnstall outdoor unit.
Fix the outdoor unit with anchor bolts (MlO)
/////
1
>60cm / 23.6"
Fig. 5.3
0
Strong wind
L::?
Fix with bolts
1:21 The area must be free of combustible gases
and chemicals.
1:21 The pipe length between the outdoor and
indoor unit may not exceed the maximum
allowable pipe length.
1:21 lf possible, DO NOT insta li the unit where it
is exposed to direct sunlight.
1:21 lf possible, make sure the unit is located far
away from your neighbors' property so that
the noise from the unit will not disturb them.
D1I lf the location is exposed to strong winds (for
example: near a seaside), the unit must be
placed against the wall to shelter it from the
wind. lf necessary, use an awning.
(See Fig. 5.1 & 5.2)
1:21 lnstall the indoor and outdoor units, cables
and wires at least 1 meter from televisions or
radios to prevent static or image distortion.
Depending on the radio waves, a 1 meter
distance may not be enough to eliminate all
interference.
Fig. 5.2
QCAUTION
Be sure to remove any obstacles that
may block air circulation.
Make sure you refer to Length
Specifications to ensure there is
enough room for installation and
maintenance.
13
Strong wind
V.2

Advertisement

loading