Graco G3-G-24MX-2L0L00-10CV00R0 Instructions Manual page 26

Setup
NOTICE
Any debris or dirt accidentally introduced into the res-
ervoir should be removed immediately. Do not allow
the pump to operate until any debris or dirt are
removed.
Operating the pump with debris or dirt in the reservoir,
may damage the pump, down stream equipment, and
bearings.
7. Clean the threads on the reservoir and the lid.
8. Replace the lid onto the reservoir, turning clockwise
(approximately 1 3/4 turns).
9. Reconnect the power to the equipment.
26
Models with a follower plate:
1. Connect fill hose to inlet fitting (D) (F
2. For higher viscosity fluids, start pump to rotate stir-
ring paddle during fill to prevent air pockets from
forming in grease.
To start the pump press the manual run
button.
3. Fill reservoir with grease until seal of
follower plate breaches the vent hole (F
the majority of air is expelled from the reservoir.
NOTE: The vent port, located in rear of reservoir, should
not be used as an overfill port/indicator/
Vent
F . 26
IG
4. Turn off the air supply (H) to the refill pump (F).
5. Remove the fill hose.
. 23).
IG
. 26) and
IG
332305R