Warning times: it ranges from 1 to 50.
5.
Click "OK" to save the settings.
4.3.7 Light Alarm
Go to AlarmLight Alarm interface as shown below.
Set the flashing time and frequency of the light.
7
Flashing time: the flashing time ranges from 1 second to 60 seconds.
Follow the alarm source: if enabled, the light will continue flashing until the detected target leaves the detection area or stops
triggering alarm.
Flashing Frequency: three options- low, middle and high
4.4 Analytics Configuration
This series of IP cameras supports certain smart functions, such as line crossing detection, region intrusion detection, etc. These
events can be triggered as alarm events.
For more accuracy, here are some recommendations for installation.
Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of detection.
Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass, lake surfaces and so on).
Avoid places that are narrow or have too much shadowing.
Avoid scenario where the object's color is similar to the background color.
At any time of day or night, please make sure the image of the camera is clear and with adequate and even light, avoiding
overexposure or too much darkness on both sides.
4.4.1 Abandoned/Missing Object Detection
Alarms will be triggered when the objects are removed from or left at the pre-defined area.
To set object removal detection:
Go to ConfigEventObject Abandoned/Missing interface as shown below.
6
5
22