Light Alarm; Smart Tracking - Speco O4P4X2 User Manual

Ptz network camera

Hide thumbs Also See for O4P4X2:

Table of Contents



Click "Upload" to upload your customized voice.

② Select the voice and then set the warning times and volume as needed.

Warning times: it ranges from 1 to 50.

③ Set the schedule of audio alarm. The setup steps of the schedule are the same as the schedule recording setup. (See

Recording).

④ Click "OK" to save the settings.

4.4.7 Light Alarm

Go to AlarmLight Alarm interface as shown below.

Light Mode: Choose "Flashing" or "Always On" as needed.

Flashing time: the flashing time ranges from 1 second to 60 seconds.

Flashing Frequency: three options- low, middle and high

The tracking option is available for line crossing detection, region entrance and exiting and intrusion detection.

Smart Tracking: When people or vehicle cross the alarm line or intrude or exit the predefined area, the PTZ camera will

automatically track them and the target image will be automatically zoomed in and centered on the screen until the target

disappears on the screen. After that, the PTZ camera will return to the tracking start position.

Tracking Mode: PTZ Auto Tracking Priority or Manual PTZ Control Priority can be optional.

PTZ Tracking Priority: if this mode is selected, in smart tracking mode, you cannot control PTZ by clicking the buttons on the PTZ

control panel in the live view interface.

Manual PTZ Control Priority: if this mode is selected, in smart tracking mode, you can control PTZ by clicking the buttons on the PTZ

control panel in the live view interface and then the camera will immediately stop the tracking action. After you finish controlling

PTZ for 5 seconds, the PTZ camera will return to the start tracking position and wait for the object to appear.

Home Position after...: If it is enabled and the time is set, when the target stops or hides behind an obstacle, or the target tracking is

complete and there is no target appearing in the detection area during the set time, the PTZ camera will return to the tracking start

position. Of course, during this time, if there are targets moving, the PTZ will continue tracking. If it is not enabled, when the target

stops or there is no target appearing in the detection area for 5 seconds, the PTZ camera will return to the start tracking position.

For example: in the crossroad, if a car is waiting for the red light for 30 seconds, and the time is set as 20 seconds, then the tracking

will stop following; but if the time is set as 40 seconds, after the red light start to change into green light, then the car re-start to

move, and the PTZ will keep on tracking this car.

How to set smart tracking:

1. Click ConfigAlarmSmart Tracking to go to the smart tracking interface. Select the tracking mode and set the "home position

after.. ." as needed.

Schedule

Table of Contents