Gira 2399 02 Operating Instructions Manual page 9

Presence detector and motion detector 360° compact
Switch on the light for 2 hours
Motions are not evaluated during this time. It is not possible to switch off via a 2-wire
extension or push-button.
￭ Press 2 h on button of the IR remote control.
Light is switched on for 2 hours. The motion detector is in automatic operation
again after the 2 hours have elapsed.
The time is restarted if actuation is repeated.
Automatic operation is switched on again using the ů button.
Switch on the light continuously
Motions are not evaluated during this time. It is not possible to switch off via a 2-wire
extension or push-button.
￭ Press the Ű button for shorter than 0.4 seconds.
Light is switched on continuously. The blue LED lights up.
Automatic operation is switched on again using the ů button.
Switch off the light for 2 hours
Motions are not evaluated during this time. It is not possible to switch on via a 2-wire
extension or push-button.
￭ Press the 2 h off button.
Light is switched off for 2 hours. The device is in automatic operation again
after the time has elapsed.
The time is restarted if actuation is repeated.
Automatic operation is switched on again using the ů button.
Switch off the light continuously
Motions are not evaluated. It is not possible to switch on via a 2-wire extension or
push-button.
￭ Press the ű button for shorter than 0.4 seconds.
Light is switched off continuously. The red LED lights up.
Automatic operation is switched on again using the ů button.
Adjusting the switch-on brightness
The switch-on brightness is set during commissioning. The switch-on brightness can
be adjusted at a later time using the PIR 2 IR remote control.
￭ Press Ų button briefly.
￭ Within 10 seconds, press the Ű or ű button briefly.
82593232 25.09.2023
9 / 25