Table of Contents
Advertisement
Presence detector and motion detector 360° compact
If day operation is set as the switch-on brightness, the light remains off con-
tinuously.
Switching via a 2-wire extension or push-button is not possible.
Switch on test operation
The test operation is used for testing the detection area. In test operation, the device
operates independently of the brightness. All the other settings remain unchanged.
Detected motions are signalled by the blue status LED.
￭
Press the Test 100 h button for between 4 and 10 seconds.
Test operation is switched on for 5 minutes.
By pressing the ů button of the supplied IR remote control, you can
switch to automatic operation at any time (see Operation).
The function is also switched off if the Reset button is pressed for between 4
and 10 seconds.
Switch on "On" for 100 h
This function is used to burn in fluorescent lamps.
￭
Press the Test 100 h button for longer than 10 seconds.
The lamps are switched on for 100 hours. The device is switched back to auto-
matic operation again after the time has elapsed.
During the 100 hours, no switching is possible via 2-wire extension, push-but-
ton or IR remote control, movement signals are not evaluated.
To switch off the function, press the Reset button for between 4 and
10 seconds.
Saving settings
Save the settings so that, if necessary, the end customer can recall them using the
Set 2 button of the supplied IR remote control. No values are saved in the as-de-
livered state.
￭
Press the Set 1 button for longer than 10 seconds.
The following settings are saved: device function, sensitivity of PIR A-C, detec-
tion angle, switch-on brightness, run-on time, dynamic run-on time, short time
operation, switch-off pre-warning. Previously saved values are overwritten.
Restoring the device to factory settings
￭
Press the Reset button for longer than 10 seconds.
Function
Device function
Operating mode
82593232
25.09.2023
Value
Motion detector
Automatic operation
21 / 25
Advertisement
Table of Contents
