SawStop REVOLUTION TSA-RMG Owner's Manual page 25

Time Saving Tip (optional)
If the needs to be removed from the
Fence Assembly
, you can quickly restore it to the calibrated
Gauge Body
offset you just established without having to re-measure.
The procedure described below takes advantage of the
set screws in the
Sliding Wedges
ADJUST THE FENCE on page 8. Tightening the set screws
will fix the wedges in their place along the dovetail-
shaped slot in the
Fence Assembly
1. Remove the silver, knurled
right side of the
Vertical Faceplate
to bump the
Sliding Wedge
draw the
Thumbscrew
2. Gently insert the
Step 1 into the hole on the left as shown above.
This hole on the
Vertical Faceplate
a set screw in the
the to tighten the set screw. Turn
Thumbscrew
the clockwise until the set screw is
Thumbscrew
snug.
3. Move the
Thumbscrew
and test that it can freely thread into the
. If the
Wedge Thumbscrew
thread freely, the
disturbed during the previous step. To fix this,
loosen the set screw slightly and correct the
position of the
Sliding Wedge
4. Tighten the
Thumbscrew
you used to ATTACH AND
.
from the
Thumbscrew
. Take care not
out of position as you
out.
you removed in
Thumbscrew
is aligned with
. Use the hex tip
Sliding Wedge
back to the center hole
does not insert and
may have been
Sliding Wedge
.
in the center hole.
5. Repeat steps 1-4 for the
Wedge
Miter
In the future, should the
to be removed from the
Thumbscrews
Thumbscrews
To replace the
the
Sliding Wedges
Faceplate
ADJUSTING PLAY IN THE GEAR
CLUSTER
If after making a miter angle adjustment and before
tightening the
Miter Gauge Body
mating between the gears in the internal gear cluster
mechanism is loose. Use the instructions below to re-
tighten the gear cluster.
Note the position of the indicator mark on the top surface
of the bushing relative to 12 o'clock and 6 o'clock as you
make changes to this adjustment. With the notch pointed
at 12 o'clock, this adjustment is fully tightened, offering
the least amount of play in the mechanism. With the
notch pointed at 6 o'clock, this adjustment is fully
loosened.
Sliding
Revolution Miter Gauge Owner's Manual
Thumbscrew
on the left side of the miter gauge.
Fence Assembly
Miter Gauge Body
completely. Set the
Fence Assembly
aside.
, align the center holes in
Fence Assembly
with the center holes on the
then secure it using the
you feel some excessive play between
Grip
and miter bar, this is an indication that
and
Sliding
assembly need
, remove both
and
Vertical
.
Thumbscrews
|
25