Fractional Degree Increments - SawStop REVOLUTION TSA-RMG Owner's Manual

Fractional Degree Increments

Should you require miter angle precision greater than whole degree increments (as described above), use the
to choose the desired degree of precision. Changing this selector affects the sensitivity of the
Degree Selector
giving a more coarse or fine response to inputs to the dial.
Dial
To read the setting for the
Degree Selector
Miter Angle Dial
the selector is set at 1/4°.
The available settings for the
Fractional Degree
Selector Setting
1/10
1/4
1/2
1
Free
Fractional
, look just beneath the
. In the example shown,
Fractional Degree Selector
Ten detents are felt between each whole degree as you rotate the
"clicks" as you turn the dial between whole degree markings on the protractor to achieve
1/10° accuracy of the miter angle setting.
Four detents are felt between each whole degree as you rotate the
"clicks" as you turn the dial between whole degree markings on the protractor achieve 1/4°
accuracy of the miter angle setting.
One additional detent is felt between each whole degree as you rotate the
Count the extra "click" between whole degree markings on the protractor to select 1/2° miter
angle settings.
Each "click" of the
Miter Angle Dial
degree.
This setting completely disengages the internal gear cluster such that there are no felt
detents as the
Miter Angle Dial
and their significance are described in the table below.
Effect
adjusts the miter angle setting by increments of one full
is rotated.
Revolution Miter Gauge Owner's Manual
Fractional
Miter Angle
. Count the
Miter Angle Dial
. Count the
Miter Angle Dial
.
Miter Angle Dial
|
13