Table - Agilent Technologies 8510XF Service Quick Reference Manual

Table 3-2

Equipment
CRT demagnetizer or bulk tape
1
eraser
Flat-head screwdriver (small)
10 dB pad
85102A/B and test set adjust software
Power Meter
Power Sensors:
50 GHz
V band
W band
Adapter, 2.4 to 1.0 mm (f-f)
Adapter, V-band to 1.0 mm (f-f)
Adapter, W-band to 1.0 mm (f-f)
Laptop, personal computer or
2, 3
controller
8510XF port power level calibration
check software
4
BASIC 6.3 or higher
Agilent VEE 4.0 Installation
1. These adjustments apply to a CRT based display only.
2. Minimum 4 megabytes of available memory after BASIC has been loaded.
3. With BASIC for Windows and PCMCIA-GPIB card.
4. Includes language extensions and drivers.
Making 8510XF Adjustments
Equipment required for 8510XF adjustments
Recommended Model
Radio Shack Model 44-233 Techno Tool (USA) or
Nietronix (Europe) 692PR022
At least 2 inches long, non-conductive
8493C
Part Number 08510-10024
437B power meter
8481A or 8482A
8487A power sensor
V8486A power sensor
W8486A power sensor
85059A K01
V281C
W281C
9000 series 200 or larger
08510-100xx
E2060B
E2120-13605
3-2 8510XF Service Quick Reference Guide
Substitute
1 to 2 amp pencil sharpening motor (base held
near CRT with motor on), or electric drill
none
8360 series source with built-in attenuator
Rev. A.01.10
438A or EPM-441A power meter
N/A
N/A
Only available as a special
N/A