Changing The Drivetrain Kit - Husqvarna 701 Enduro 2017 Repair Manual

14 WHEELS
116
Lay the rear wheel on a workbench with the rear sprocket facing upwards and
insert the wheel spindle in the hub.
To check play
©
, hold the rear wheel tight and try to turn the rear sprocket with
your hand.
VA
f i
\ /
i \
Info
Measure the play on the outside of the rear sprocket.
I
I
&
'yi
©
Play in rubber dampers, rear wheel < 5 mm (< 0.2 in)
/
A
V00511-10
t
If clearance
o
is larger than the specified value:
- Change all rubber dampers in the rear hub.
Finishing work
- Install the rear wheel. (Hi p. 104)
- Remove the motorcycle from the lift stand. (Hi p. 12)
- Check the chain tension, (Hi p. 110)
14.8.16 Changing the drivetrain kit
Preparatory work
- Raise the motorcycle with the work stand. (81 p. 12)
Main work
- Remove screws O and ©■
- Remove the engine sprocket cover.
©
'V' _
_ -_ _ ;
o
k
R01421-10
Bend up lock washer
Have an assistant operate the rear brake.
Remove the nut with the lock washer.
Remove the rear wheel using a work stand. (Hi p. 105)
m
hem
'*
SI*
' A
\ D02826-1Q
Open the chain. (Hi p. 114)
Info
Cover the components to protect them against damage.
I
*
*% ,® ©
Remove engine sprocket ©.
Slide new engine sprocket O onto the main shaft.
Mount the new chain.
Rivet the chain. (Hi p. 114)
f
■ if
__
R01423-10
Remove fittings
0
. Take off the rear sprocket.
Position the new rear sprocket. Mount and tighten the fittings.
Guideline
v
\V
T
Loctite® 2701™ Nut, rear sprocket screw M8 35 Nm
(25.8 Ibf ft)
Install the rear wheel using a work stand. (Hi p. 106)
e.
x
D02825-10
/
A