Table of Contents
Advertisement
27 CLEANING/PROTECTIVE TREATMENT
266
Cleaning the motorcycle
27.1
Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
60 cm (23.6 in)
Warning
Environmental hazard Hazardous substances cause environmental damage.
- Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
I
Close off the exhaust system to keep water from entering.
Remove loose dirt first with a soft jet of water.
Spray very dirty parts with a normal commercial engine cleaner and then brush
off with a soft brush.
r
]
>
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always rinse the vehicle
with water first.
If the vehicle was operated in road salt, clean it with cold water. Warm
water would enhance the corrosive effects of salt.
I
401061-01
After rinsing the motorcycle with a gentle spray of water, allow it to dry
thoroughly.
Remove the closure of the exhaust system.
Warning
Danger of accidents Moisture and dirt impair the brake system.
- Brake carefully several times to dry out and remove dirt from the brake
linings and the brake discs.
A
After cleaning, ride the vehicle a short distance until the engine warms up.
Info
The heat produced causes water at inaccessible locations in the engine
and on the brake system to evaporate.
I
Push back the protection caps of the handlebar controls to allow any water that
has penetrated to evaporate.
After the motorcycle has cooled off, lubricate all moving parts and bearings.
Clean the chain. p. 115)
Treat bare metal (except for brake discs and the exhaust system) with a corrosion
inhibitor.
Preserving materials for paints, metal and rubber (ii p. 318)
Treat all painted parts with a mild paint care product.
Info
Do not polish parts that were matte when delivered as this would strongly
impair the material quality.
I
Advertisement
Table of Contents
