Table of Contents
Advertisement
3503 Signal Cable
ModelOlL
Removal
1.
Switch off the printer power.
2.
Disconnect the signal cable
O.
3.
Remove the top cover (3052).
4.
Remove the logic/control board safety cover
(3502).
5.
Disconnect the signal cable from logic/control
board connector
J
6
e.
6.
Loosen the power supply mounting screw that
holds the signal cable clamp
G.
7.
Remove the screw
e
that holds the cable mount-·
ing bracket to the printer base. Do not remove
this bracket from the cable.
3-104
SY34-0613
8.
Remove the signal cable from the printer.
Reinstallation
1.
Reinstall the signal cable into the printer.
2.
Reinstall screw
e
and fasten the cable mounting
bracket· to the printer base.
3.
Place the cable in the cable clamp
G
and tighten
the power supply mounting screw.
4.
Connect the signal cable to logic/control board
connector
J
6
e.
5.
Reinstall the logic/control board safety cover
(3502).
6.
Reinstall the top cover (3052).
7.
Connect the signal cable to the host device.
Advertisement
Table of Contents
