Section 2. Connecting The Cable(S) To The Printer; Set The Power Switch To Off - IBM 5256 User And Setup Manual

Section 2. Connecting the Cable(s) to the Printer
1. Set the Power switch to Off.
Before connecting the cable to your printer, make sure the other end is
connected to a system, a display station, or another printer.
System
Dual Display Station
Printer
Display Station
Cables
If the cable you are connecting to your printer comes from a 5252 Dual
Display Station, a 5251 Display Station Model 1 or 11, or a 5256 Printer,
make sure that the Terminator switch on that machine is set to 2.
The following illustration shows where the Terminator switch is located.
5252 Dual
Display
Station
5251 Display
Station Model
1 or 11
5256P~_
Term i nator Sw itch
---
---------
Connecting the Cable(s) to the Printer 2-1