Table of Contents
Advertisement
3054 Placing the Printer in Operating Position
1.
Remove the front base screw
CD
on the right side,
and loosen the front base screw "
on the left
side.
2.
Place the printer back into the operating position
on the printer base.
3.
Reinstall and tighten the base screws
CD
on the
right side.
4.
Tighten the base screws" on the left side.
5.
Connect:
a.
Forms feed emitter cable connector P9
G.
b.
Motor cable connectors P5
G
and P7
o.
c.
End-of-forms/print emitter cable connector
P8G·
6.
Connect print head cable connector P4
e
and
install the print head cable clamp
O.
Ensure that
the print head cable is against the flat spring.
7.
Reinstall the logic/control board safety cover
(3502).
8.
Reinstall the top cover (3052).
3-6
SY34-0613
Advertisement
Table of Contents
