Models 102, 1I1, And 4I3 Twinaxial Attachment; Attaching A Twinaxial Signal Cable To The Printer - IBM 102 User Manual

Models 102, 1I1, and 4I3 Twinaxial Attachment

Supported computers include:
System/36
Application System/400* (AS/400*)
5294 and 5394 Remote Control Units.

Attaching a Twinaxial Signal Cable to the Printer

To attach a twinaxial cable (not shipped with the printer), follow these
steps:
1. Set the address. If your desired printer address is 0, go to Step
3 on page 2-4. If your desired printer address is not 0, see the
following table for the valid values and follow Steps 1a on
page 2-3 through 1g on page 2-4 to change the value. If you
do not know what to assign for the printer address, check with
your system operator.
If Desired
Address Is:
0
1
2
3
4
5
6
2-2
User's Guide
Shown when Setting
Set: Printer Address:
000 Printer Address=0
001 Printer Address=1
002 Printer Address=2
003 Printer Address=3
004 Printer Address=4
005 Printer Address=5
006 Printer Address=6