3206 A-frame Alignment
Service Check
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Remove the ribbon shield (3355).
Print head
3-30 SY34-0613
4.
Set the copy..,control dial to O.
5.
Measure the gap. between the platen and the
print head at both ends of the platen. The gap
should be 0.25 to 0.30 mm (0.010 to 0.012 in.).
6.
If
the gap at either end is not correct, perform the
following adjustment starting at step 5.