Table of Contents
Advertisement
Model02R
Removal
1.
Switch off the printer power.
2.
Disconnect the signal cable
«)
from the modem or
the host system.
3.
Remove the top cover (3052).
4.
Remove the logic/control board safety cover
(3502).
5.
Disconnect the signal cable from logic/control
board connector 16
e.
6.
Loosen the power supply mounting screw that
holds the signal cable clamp
e.
7.
Remove the screw
e
that holds the cable mount-
ing bracket to the printer base. Do not remove this
bracket from the cable.
8.
Remove the signal cable from the printer.
Reinstallation
1.
Reinstall the signal cable into the printer.
2.
Reinstall screw
e
and fasten the cable mounting
bracket to the printer base.
3.
Place the cable in the cable clamp
e
and tighten
the power supply mounting screw.
4.
Connect the signal cable to logic/control board
connector 16
e.
5.
Reinstall the logic/control board safety cover
(3502).
6.
Reinstall the top cover (3052).
7.
Reconnect the signal cable.
Maintenance Procedures
3-105
Advertisement
Table of Contents
