3201 Forms Feed Platen Gear
Service Check
1.
Switch off the printer power.
2.
Turn the platen knobs one rotation.
If
a bind
occurs, perform the following adjustment:
Adjustment
1.
Switch off the printer power.
2.
Remove the top cover (3052).
3.
Loosen
the
three
forms
feed
stepper
motor / emitter mounting nuts
G.
3-24
SY34-0613
4.
Turn the gears until one of the holes
e
in the
idler gear is radially aligned with the gear shafts,
as shown at
O.
5.
Reinstall the platen (3101).
6.
Place the stepper motor up and to the rear so that
the gears mesh tightly.
7.
Tighten the three mounting nuts
G.
8.
Check for binds and adjust again if necessary.
9.
Remove the platen (3101).
10. Reinstall the top cover (3052).