Ibm Pc/At And Compatibles - Yamaha MU100 Owner's Manual

IBM PC/AT and Compatibles

Follow these instructions if you have an IBM PC/AT or compatible com-
puter not equipped with an external MIDI interface. Connect the TO HOST
terminal on the MU100 to one of the computer's serial ports, COM 1 or
COM 2.
IBM PC/AT and Compatible
The instructions below assume you are running Windows95 or 98 on your
PC. For using the TO HOST connection with other software and operating
systems, consult your Yamaha dealer. If your computer and music software
cannot recognize the TO HOST connection, you can still use the MU100 by
installing a MIDI interface (internal card or external) to the computer.
Operation
1 Install the included driver software.
For Windows95 or 98
Install the included Yamaha CBX Driver.
The driver software is on a CD-ROM included with the MU100.
Make sure to thoroughly read the "\CBX driver\readme.txt" on the
disk. This contains essential information on installing and setting
up the driver on your computer.
2 Set the HOST SELECT switch to PC-2.
3 Connect the MU100 to the host computer.
Refer to the illustration above. Use a standard computer cable
(8-pin Mini DIN to 9-pin D-SUB; see page 92).
4 Turn on the the host computer, then the MU100.
5 Start up your music software.
If necessary, set up the appropriate options on the software for
operation with the MU100. The relevant settings may be found
in menu(s) called "Studio Setup," "System Setup," or "MIDI
Setup."
Setting Up the MU100 in Your Music System
Serial Port
Guided Tour
37