Yamaha MU100 Owner's Manual page 55

5 Select "F#3: Timbale L."
Play F#3 on the connected keyboard, or use the [PART -/+]
buttons to select "F#3."
6 Select the LPF Cutoff parameter, and set it to –40.
7 Select the LPF Resonance (LPF Reso) parameter, and set it to
+63.
8 Select the Velocity LPF Sensitivity parameter (VelLPFSens), and
set it to +16.
Play the key softly to strongly and notice how key velocity
changes the timbre of the sound for a "wah-wah" effect.
More Drum Editing
Try some of the other parameters in the edit menus (FILTER, EG, VIBRATO,
OTHERS) on your own and hear how they affect the drum sounds. Keep in
mind that these are applied to the entire Part, and cannot be set individually
for each sound.
As a springboard for further exploration, try editing the following parameters
in the OTHERS menu:
1. With a drum Part selected, call up the OTHERS parameters.
Press [EDIT], select "OTHERS," then press [ENTER].
2. Select "PitBndCtrl" and set the value to +24.
Play with the pitch bend wheel on the connected keyboard while playing
different keys.
3. Select "MW LFOPMod" and set the value to 090.
Play with the modulation wheel on the connected keyboard while playing
different keys.
Select and change other parameters in the same way.
NOTE
Some of the parameters (such as Release Time in the EG menu) may not have
any affect on the drum sounds at all. Also, the effect of a parameter may differ
depending on the specific drum sound. (For more information on editing Drum
Parts, see page 114.)
Guided Tour
Editing in the Multi Mode
57