Variation (Var) - Yamaha MU100 Owner's Manual

Variation (VAR)

Variation (VAR)

The Variation section provides a wealth of additional effects for processing the
Voices of the MU100. It features some of the same effects found in the Reverb,
Chorus and Insertion sections. This is not mere redundancy; it allows you to
use two types of Reverb, Chorus or other effects on different Voices. For ex-
ample, you may want to have the Flanger effect on one Voice and Phaser on
another. Variation also gives you many special effects not found in the other
sections, such as Delay, Gate Reverb, Wah and Pitch Change.
The Variation section of effects can be applied either to a single selected
Part or to all Parts, depending on the connection setting: Insertion or Sys-
tem. (See About the Effect Connections — System and Insertion on page
139 for more information.)
Explanations of the Variation Type and other common parameters are
given below. For specific descriptions of Variation Types and explanations
for all other Variation parameters, refer to the separate SOUND LIST &
MIDI DATA booklet.
Type
Settings: NO EFFECT; HALL 1 — 2;
ROOM 1 — 3; STAGE 1 — 2;
PLATE; WHITE ROOM;
TUNNEL; CANYON; BASE-
MENT; DELAY L,C,R; DELAY
L,R; ECHO; CROSS DELAY;
ER 1 — 2; GATE REVERB;
REVERSE GATE; KARAOKE
1 — 3; CHORUS 1 — 4;
CELESTE 1 — 4; FLANGER
1 — 3; SYMPHONIC; EN-
SEMBLE; DETUNE; AMBI-
ENCE; ROTARY SPEAKER;
2WAY ROTARY SPEAKER;
TREMOLO; AUTO PAN;
PHASER 1 — 2, DISTOR-
TION; COMP+ DISTORTION;
OVER DRIVE; AMP SIMULA-
TOR; 3BAND EQ (MONO);
2BAND EQ (STEREO); AUTO
WAH (LFO); AUTO
WAH+DIST; AUTO
WAH+ODRV; TOUCH WAH 1;
TOUCH WAH+DIST; TOUCH
WAH+ ODRV; TOUCH WAH
2; PITCH CHANGE 1 — 2;
AURAL EXCITER
PRESSOR; NOISE GATE;
VOICE CANCEL; TALK MOD;
136
* Aural Exciter
NOTE
When NO EFFECT or THRU is selected for
the Type, no Variation effect is applied, and
only the common parameters shown below
are available (with the exception of Dry/Wet).
The NO EFFECT setting cancels the Variation
effect. When the Variation Connection is set
to SYS (System), the sound can be heard with
no effect. When the Variation Connection is
set to INS (Insertion), no sound is output for
the Part.
When set to THRU, the sound of the Part (or
Parts) is output without any Variation effect.
Generally, when Variation Connection is set
®
; COM- to INS (Insertion), you should set the Type to
Thru. When Variation Connection is set to
SYS (System), you should set the Type to NO
EFFECT.
Effect Edit Mode
LO-FI; DIST+DELAY;
ODRV+DELAY;
CMP+DT+DL Y;
CMP+OD+DLY;
WAH+DT+DLY;
WAH+OD+DLY; THRU
® is a requistered trademark
of Aphex Corporation.