Installing A Plug-In Board Into The Mu100 - Yamaha MU100 Owner's Manual

Installing a Plug-in Board into the MU100

Warning
Installation and removal of a plug-in board into the MU100 initializes some of the
setup and multi-part settings of the main unit. Be sure to save any of your important
settings onto a personal computer or MIDI Data Filer MDF3 before installing or
removing a plug-in board.
CAUTION!
Be careful not to injure your hands or fingers while installing or removing the plug-
in board.
Be careful not to injure yourself when handling the jagged surfaces or sharp areas of
the plug-in board.
Instructions
1 Turn off the power of any devices that may be connected to the
MU100 and remove the MU100's AC adaptor from its power
source.
CAUTION!
Accidents can occur if the plug-in board is installed or removed while the AC
adaptor is connected to a power source. Be sure to unplug the AC adaptor of the
MU100 before installing or removing the plug-in board.
2 Turn the MU100 upside down.
Remove the installation lid by removing the four (4) silver
screws that secure it to the MU100.
Installing the Optional XG Plug-in System
Appendix
167