Installing and Starting the Plug-in Editor Software
Installing the Software
Double-click the "Setup.exe" ﬁle in the "plg-an" folder on the ﬂoppy disk to start the installation.
Click "Next" or "Yes" and follow the subsequent instructions on the screen to complete the installa-
Starting the AN Easy Editor
Start XGworks (or XGworks lite).
Click the "Plug-in" menu and select "AN
Alternately, press Alt + P, then A, and ENTER. The
"Select AN Part" dialog box appears.
Set the desired Part number and click "OK."
The AN Easy Editor window appears.
If the PLG150-AN has been
properly installed and all com-
puter/MIDI connections have
been properly made, operating
the AN Easy Editor should
directly affect the PLG150-AN.
For details on using the AN Easy
Editor, refer to the on-line help
ﬁle that is included with the soft-
When using a Modular Synthesis Plug-in System "mother" device, the Part assignment depends on
which mode is used — Voice or Performance — and also on whether the PLG150-AN board is
installed/assigned to PLG1 or PLG2, as described below.
When using the Voice mode:
Depending on which slot the PLG150-AN board has been installed to, press PLG1 or PLG2, then
set the Part to "1" (no matter what the PLG1 or PLG2 assignment is).
When using the Performance (Multi) mode:
If the PLG150-AN board is assigned to PLG1, set the Part to "16."
If the PLG150-AN board is assigned to PLG2, set the Part to "15."