Table of Contents
Advertisement
Shutdown:
The system can be turned off at any time by turning off the power switch without damaging the
system.
Note:
1. Check that your equipment is receiving power before use.
2. If there is any problem with the machine or power cable, please contact the place of purchase.
Slope Motor Calibration
In the standby state, hold down the external incline plus or minus key for 3 seconds at the same time,
and the system will enter the automatic incline calibration. When calibration is complete, the system
will exit automatically.
If E04 is reported during the learning process, check the motor, motor signal cable, or replace the driver.
18
| COMPUTER OPERATION
Advertisement
Table of Contents
