Table of Contents
Advertisement
D12
B17
D08
C28
STEP 3:
1. Fasten the upper segment line (E09) and lower segment line (E10) as shown in the figure. Then use the
hex wrench (B17) 2-in-1 screw (D12*4) to fix the electronic meter group (F) to the instrument tube
group (A02) and lock it tightly.
CAUTION: Pay special attention not to clip the line!
2. Use a cross wrench (B18) and left pedal (C45) to fix it on the left crank (B01) in counterclockwise turn.
Ensure it is fully tightened.
3. Use a cross wrench (B18) with the right pedal (C46) to fix it on the right crank (B02) in clockwise turn.
Ensure it is fully tightened.
CAUTION: Be careful not to cross thread the pedals and fully tighten before use. On the right side is a
clockwise turn and on the left side is a counterclockwise turn.
4. Fasten the front foot cover (C28) on the main frame assembly (A) and lock it with the cross-pan head
screw (D08), as shown in the figure.
F
E09
E10
A02
C46
B02
B01
C45
B18
A
D08 M5*10 x 1pc.
D12 D24
D12 M6*12 x 4pcs.
B18 S13-15 x 1pc.
B17 S5 x 1pc.
ASSEMBLY INSTRUCTIONS |
9
Advertisement
Table of Contents
