Panasonic EYADA Series Operating Instructions Manual page 85

c3 Count Return Setting
You can set how fastened screws
determined as OK are counted
when reversing rotations to redo or
loosen them.
■ Setting Procedure
Switch to setting mode.
Set the forward/reverse lever to
the trigger switch lock position, and
hold down the OK button.
Choose "c3" by pressing
the ▲ and ▼ buttons, and
press the OK button.
A set value appears on the display.
Select a desired one by
pressing the ▲ and ▼
buttons.
The default is "_1".
Display
( Reverse rotations are
not counted.)
( The count is put back
by reverse rotations.)
( The count is reset by
reverse rotations.)
P. 22
Count return
OFF
Return 1 count*
Return to start
When it is set to "_1"
1
The 2nd screw is
redone.
(Reverse rotations)
* In a state where no screws are
fastened, reverse rotations will not
cause the count to go back beyond the
default.
* To reverse the rotation when the
number of screws set through the
count quantity is reached, set a waiting
time through " c7 Batch Complete
Judgement Waiting Time Setting".
P. 31
Press the OK button to
confirm it.
When the setting is completed, a
buzzer sounds long (a long beep),
and the display returns to the menu
screen.
Back to Operation Mode.
Hold down the OK button.
P. 22
2
The count
goes back
by one.
27
EN