Panasonic EYADA Series Operating Instructions Manual page 111

■ Error codes for errors that occur during work.
Display Possible cause
During a fastening
process, the tool was
stopped before the
clutch activated.
During a fastening
process, the rotation time
has become higher than
the upper limit or lower
than the lower limit.
During a fastening
process, the forward/
reverse lever was
switched.
During a fastening
process, the tool was
overloaded or the motor
failed.
During a fastening
process, a cord or
cords became poorly
connected.
During a fastening
process, the internal
protective sensor
became out of order.
During a fastening
process, the tool
became hot.
Action
Nothing is wrong with the
product.
Keep the tool in action until
the clutch activates.
Nothing is wrong with the
product.
Check the workpiece and the
setting for the rotation time.
P. 35
Do not switch the forward/
reverse lever during a
fastening process.
Eliminate the condition(s)
that caused the overload and
recheck the condition.
When this does not eliminate
the problem, send the tool
for repair.
Check whether the cords
are correctly connected
and whether no cords are
broken.
When no abnormality is
found in the cords, the power
adapter may be failed. Send
the tool for repair.
Send the tool for repair.
Interrupt the work and wait
for it to cool down before use.
53
EN