Panasonic EYADA Series Operating Instructions Manual page 78

HOW TO USE
Starting Work
Set the rotation direction
with the forward/reverse
lever.
When you set it to the "F" position
and the "R" position, the motor
rotates forward (clockwise) and
reverses (anticlockwise) respectively.
Forward (Clockwise)
Reverse (Anticlockwise)
NOTE
⿟ If the forward/reverse lever is
switched while the motor is
in action, the motor is forcibly
stopped to rotate.
20
EN
(cont.)
⿟ There may be a slight delay in
R position
⿟ In case of quick ON/OFF, the
F position
⿟ You can select "lever start" or
Checking Fastening Status
This unit notifies you of the work status
with a buzzer and the detection lamp.
■ Fastening OK
When the clutch activates and the screw
is normally fastened, the buzzer emits a
short beep and the detection lamp lights
up in green to tell you that the screw has
been normally fastened.
You can also use the rotation time in
combination as determination criteria.
• The detection conditions can be changed
in the menu.
• The lighting colour of the lamp can be
changed in the menu.
Start rotation.
In "lever start" mode, pull the lever.
In "push start" mode, push toward
the bit.
Lever start
the rotation startup at the start,
but it is not a failure.
rotation startup will be late a
little for that.
"push start" for start mode.
P. 35
Detection lamp
Solid green
A short
beep
OK
Push start
P. 17
P. 39