Error Codes - Panasonic EYADA Series Operating Instructions Manual

ERROR CODES

If there is any problem, an error code blinks on the display of
the tool.
Consult the table below and take a necessary action.
• [E0] to [E7]
Pressing the OK button will clear the error display.
• [EE] and [F2] to [Fb]:
Press the OK button. Or pressing a switch will clear the error
display.
If the problem persists, stop the use immediately.
Bring it to your dealer.
Display
52
EN
Possible cause
In the setting mode, an
inappropriate setting is
input.
The tool is hot.
The internal protective
sensor is out of order.
The tool is overloaded
or the motor is out of
order, for example.
A cord or cords are not
correctly connected.
The tool circuit is failed or
out of order, for example.
The communication
cable is broken or poorly
connected, for example.
Action
Review the setting to correct
it.
P. 54
Interrupt the work and wait
for it to cool down before use.
Send the tool for repair.
Eliminate the condition(s)
that caused the overload and
recheck the condition.
When this does not eliminate
the problem, send the tool
for repair.
Check whether the cords
are correctly connected and
whether no cords are broken.
When no abnormality is
found in the cords, the power
adapter may be failed. Send
the tool for repair.
Send the tool for repair.
Check the communication
cable.