Table of Contents
Advertisement
To dispense fluid in Preset Dispense mode:
1.
Wake up metered dispense valve by
pressing any button on the metered
dispense valve key pad (F
2.
Enter PIN or Work Order (if required by
metered dispense valve set-up
parameters).
3.
Use the RIGHT arrow to highlight
PRESET (H) on the screen. Press
ENTER to select PRESET(F
F
. 35
IG
4.
Use the UP and DOWN arrows to toggle
between the preset values. (A maximum
of five presets can be defined using the
Pulse Fluid Management Software.)
When the desired preset value displays,
press ENTER.
5.
ACTIVATE (D) is highlighted on the
screen. Press ENTER to select
ACTIVATE.
6.
Pull the trigger to dispense fluid. (The
display (E) shows the amount
dispensed.)
NOTE: For changing the preset value or to
stop the dispense at any time before
reaching the preset amount, release the
trigger to stop the fluid flow. Use the RIGHT
or LEFT arrow to select STOP (J). Press
ENTER.
3A7397E
. 1, page 7).
IG
. 35).
IG
Change Preset Before Dispense is
Started
1.
Highlight ACTIVATE (D)on the screen.
Press ENTER.
F
. 36
IG
2.
Use the UP and DOWN arrows to
change the preset value by increments
of 0.1.
3.
Pull the trigger to dispense fluid.
Change Preset After Dispense is
Started
1.
Perform Steps 1 - 5 of the Preset
Dispense procedure, page 21.
2.
Pull the trigger to dispense fluid until a
quantity LESS than the preset amount is
dispensed.
3.
Use the RIGHT or LEFT arrow to select
STOP (J) (F
. 37). Press ENTER.
IG
F
. 37
IG
4.
Use the LEFT or RIGHT arrows to select
PRESET (H). Press ENTER (F
Operation
. 38).
IG
21
Advertisement
Table of Contents
