Graco Pulse 26C935 Installation And Operation Manual page 19

3. Continue this process until the 4- or
5-digit PIN Code has been entered.
4. After the last number is entered, the
cursor automatically moves over the
"✔". Press ENTER to send the PIN Code
entry to the Pulse Fluid Management
Software.
The message VALIDATING appears on
the display (F
IG
F . 31
IG
If the Pulse Fluid Management Software
recognizes the PIN Code and authorizes the
dispense, a Dispense Screen displays.
If the Pulse Fluid Management Software
does not recognize the PIN Code, the
metered dispense valve will not authorize a
dispense and INVALID displays.
3A7397E
. 31).
Authorization Using an NFC FOB
Touch the NFC fob over the indicator at the
top of the bezel, as shown in F
the NFC Code to the Pulse Fluid
Management Software for authorization.
F . 32
IG
The message VALIDATING (F
on the display.
If the Pulse Fluid Management Software
recognizes the NFC Code and authorizes the
dispense, a Dispense Screen displays.
If the Pulse Fluid Management Software
does not recognize the NFC Code, the
metered dispense valve will not authorize for
a dispense and INVALID displays.
NOTE: The NFC Code requires that the NFC
fob be read in ten (10) seconds. If the NFC
Code is not read, the meter will default to the
PIN Code entry screen.
Set-Up
. 32, to send
IG
NFC FOB
. 31) appears
IG
19