Installation
Install the Metered
Dispense Valve
1.
Follow Pressure Relief Procedure,
page 10.
b
F
. 8
IG
2.
Slide the swivel boot (a) back over the
hose, the small end first, to access the
swivel fitting (6) (F
3.
Apply thread sealant to the male threads
of the hose fitting.
4.
Thread the hose fitting (b) into the
metered dispense valve swivel (6).
5.
Use two wrenches to tighten securely
(F
. 8).
IG
NOTE: Make sure to let the sealant cure
according to the manufacturer's
recommendations before circulating fluid
through the system.
12
a
6
. 8).
IG
Install the Extension Tube
1.
Adjust the nut (c) on the extension (2) to
ensure maximum thread engagement of
the extension (F
F
. 9
IG
2.
Thread the extension (2) into the
housing until it bottoms out (F
3.
Align the extension (2) with the metered
dispense valve housing and handle (16)
(F
. 9).
IG
4.
Firmly tighten nut (c) (F
. 9).
IG
2
c
16
. 9).
IG
. 9).
IG
3A7397E