Installation; General; Reception Of Goods; Lifting - Salda AMBERAIR COMPACT S-CX H Operation, Installation & Maintenance Instructions

4. INSTALLATION

4.1. GENERAL

Personnel must be trained before starting to use the unit. Any damages to the unit or its components are not covered by warranty if the require-
ments are not fulfilled.
The product identification labels are located on the inspection side of the air handling unit.
The air handling unit is supplied in a special package.
Ordered accessories are supplied in separate packages.

4.2. RECEPTION OF GOODS

Each device is carefully checked before transportation. When receiving the goods, checking the devices for any damage made during transpor-
tation is recommended. If any damage to the unit is observed, immediately contact the representatives of a transport company. Please inform the
representative of the manufacturer, if any deviation of the device is noticed.

4.3. LIFTING

The product can be lifted with a forklift or a crane using slings. When lifting with a forklift, the length of the fork must be greater than the length or
width of the product (depending on the product version).
To prevent damage to the casing, only a product placed on a pallet should be lifted.
When lifting the product with the slings, it is required to insert spacers between them to prevent damage to the casing.

4.4. TRANSPORTATION AND STORAGE

• All units are factory-packaged to withstand normal conditions of transportation.
• When unpacking, check the unit for any damage made during transportation. Installing the damaged units is not allowed!
• The packaging is used for protection purposes only!
• When unloading and storing the units, use suitable lifting equipment to avoid damage and injuries. Do not lift units by holding on power supply
cables, connection boxes, air extract or exhaust flanges. Avoid hits and shock overloads. Before installation, the units must be stored in a dry
room with relative air humidity not exceeding 70 % (at +20 °C) and with an average ambient temperature ranging between +5 °C and +30 °C.
The storage place must be protected against dirt and water.
• The units must be transported to the storage place or installation site using forklifts.
• The recommended storage period should not be longer than one year. In case of storing the units for a period longer than one year, checking if
the fan bearings and motor rotate without difficulty (turning the impeller by hand) and if the electric circuit insulation is not damaged or the mois-
ture has not accumulated must be performed before the installation of the unit.
Before installation Air Handling unit must be stored in clean and dry premises in their original packaging. If the unit is installed
but not yet in use, all connection openings must be tightly closed and the unit must be additionally protected against environ-
mental influences (dust, rain, cold, etc.).
AMBERAIR COMPACT S-CX v2023.3
Fig. 4.3.1 AmberAir Compact lifting with a forklift
Fig. 4.3.2 AmberAir Compact lifting with slings
EN | 9