Table of Contents
Advertisement
Installation Guide
4.8 Mounting the slider
The assembly of the load mass by means of the M5 thread has to be done in such a way that only the end
piece of the slider facing the load mass is held with a suitable open-end spanner no.10 (Attention: magnetic
attraction!). Under no circumstances may the sensitive slider tube be used as a clamping piece.
The load must be supported by a linear guide to prevent lateral forces on the slider and
wear on the stator and slider.
•
When mounting the load, the open-end spanner may only be used to tighten the screw
on the side of the slider facing the load (see following illustrations).
•
The tightening torque for the M5 screw on the slider is 4.5 Nm.
NTI AG / LinMot
MagSpring
MS01
M = 4,5 Nm
ENG
Incorrect
assembly
Correct
assembly
Page 15 / 25
Advertisement
Table of Contents
