Table of Contents
Advertisement
Installation Guide
4.5 Inserting the slider into the stator
•
Be sure to observe the safety instructions in chapter 2 during assembly!
•
No lateral force on the slider during assembly or operation!
Attention! During insertion the slider is pulled into the stator with great force and shoots out
of the stator on both sides.
After installing the slider, the warning sticker "Attention Magnets" must be placed on the
machine near the MagSpring.
4.6 Zero position of the slider and start position of the constant force
During installation, note that the constant force range of the MagSpring begins at a distance
of 35 mm (1.38 in) from the end of the slider to the end of the stator.
NTI AG / LinMot
MagSpring
In the relaxed state, the slider is approximately in the
centre of the stator, with the square working end, to
which the load is to be attached, protruding slightly
less from the stator. This is the Zero Position (ZP)
of the slider.
Starting from this resting position, the restoring force
increases to the nominal value when the slider is
pulled out of the stator. At a distance of 35 mm from
the end of the stator is the Starting Position of the
constant force (SP).
MS01
1. The force class and serial number are lasered
on the two-edged end of the slider:
E.g.: 2301.2304308.022-20 stands for serial
number 2301.2304308 and force class 20.
The end of the slider with the lasered lettering
is on the side facing away from the load.
2. Clean the slider with a paper towel.
3. Grease the slider according to the lubrication
instructions (see chapter 5.2).
4. Insert the slider with the square end exactly in
the longitudinal direction into the stator. Here,
observe the above note.
ENG
Page 11 / 25
Advertisement
Table of Contents
