Installation Guide
•
Then grease the stator bore with 2-3 g of LU02 grease, whereby there should only be a light film of
grease on the inside.
Note: Avoid overgreasing!
•
Finally grease the slider according to the previous section "lubrication during assembly".
5.2.4 Detergent / Lubricant
For cleaning MagSpring stators and slider, the cleaning spray LU06 is recommended.
LinMot grease LU02 is prescribed to improve the sliding properties between the chrome-nickel steel surface
of the slider and the plastic plain bearing.
Ordering information
Article
Description
LU06-250
Klüberfood NH1 4-002 Spray*
LU02-50
Lubricant for linear motors**
LU02-1000
Lubricant for linear motors**
* LinMot Spray LU06 is identical to KLÜBERFOOD NH1 4-002 (food grade UH1 approval).
**LinMot Grease LU02 is identical to KLÜBERSYNTH UH1 14-31 (food grade UH1 approval).
6 Storage and Transport
•
LinMot and MagSpring sliders may only be transported and stored in their original packaging.
•
The sliders should not be removed from the packaging until they are installed.
•
The storage room must be dry, dust-free, frost-free and vibration-free.
•
The relative humidity should be less than 60 %.
•
Prescribed storage temperature: -15 °C...70 °C.
•
The MagSpring must be protected from extreme weather conditions.
•
The room air must not contain any aggressive gases.
Page 22 / 25
MagSpring
(50 g)
(1000 g)
MS01
Item no.
(250 ml)
0150-2394
0150-1954
0150-1955
ENG
NTI AG / LinMot