Patch Out Page; Patch Signals To Output Jacks - Yamaha AW4416 Reference Manual

SET UP screen

Patch signals to output jacks

[Function]
Assign output signals to the OMNI
OUT jacks, STEREO OUT jacks,
DIGITAL STEREO OUT jack, and
the output channels of I/O cards.
[Key operations]
• [SETUP] key [F2] (Patch OUT)
(*1)
key
• Repeatedly press the [SETUP]
key until the display shown at
right appears.
*1. In the SET UP screen, the tabs
displayed at the bottom of the
screen are divided into two
groups. If the Patch OUT tab is
not assigned to the [F2] key
when you press the [SETUP]
key, press [SHIFT] key + [F1]
(CHANGE TAB) key to switch
the tabs.
[Mouse operation]
M button SETU button
[Screen functions]
A
OMNI OUT ASSIGN
Select the signals that will be output from the
OMNI OUT 1–4 jacks. The following signals
can be assigned.
Display
AUX 1–AUX 8 AUX buses 1–8
Recorder direct outputs 1–
RDR 1–RDR16
16
L/R channels of the stereo
ST L/ST R
output channel
BUS 1–BUS8 Bus 1–8
Input channel direct out 1–
DIR 1–DIR16
16
16
— Reference Guide

Patch OUT page

1
2
4
Patch OUT tab
Signal type
B
D.ST OUT ASSIGN (digital stereo out
assign)
C
ST OUT ASSIGN (stereo out assign)
These respectively select the pair of signals that
will be output from the DIGITAL STEREO OUT
jack and the STEREO OUT jack. The following
signals can be assigned.
Display
ST L/R Stereo output channel
BUS 1/2–BUS 7/8 Bus 1/2–7/8
Input channel direct out 1/
DIR 1/2–DIR15/16
2–15/16
AUX 1/2–AUX 7/8 AUX buses 1/2–7/8
RDR 1/2–RDR15/ Recorder direct outs 1/2–
16 15/16
3
Signal type