Sweep; Sweep_Count - BRUEL & KJAER 1053 Instruction Manual

5.4.63. Sweep?
or
SWeep DOwn_ Trigger
or
SWeep STop
Notes:
- Enables Sweep Control "Down" to be initiated
by GET
- Stops/pauses the sweep as in Sweep Control
"Stop"
A triggered sweep starts by sending GET (Group Execute Trigger).
SWEEP can only be used when Generator Output is in "Operate" or "Operate -20dB".
Enables read out of the Sweep Control status.
Example of Use:
SWeep?
enables read out of:
SW Up
or
SW Up_T
or
SW Down
or
SW Down_T
or
SW STOP
5.4.64. Sweep_Count
Sets the number of frequency sweeps as in the front panel Sweep "Count" function.
Example of Use:
Sweep_Count 25
Sweep_Count Continuous
Notes:
- Sets the sweep count to 25
- Sets the sweep count to Continuous sweep
The limits are 1 to 9999 or Continuous. 10000 is allowable and selects Continuous
sweep.
5.4.65. Sweep_Count?
62
Enables the read out of the sweep count and the total elapsed sweeps, as displayed
when the Sweep "Count" front panel function is activated.