Inta Intatherm IT1005CP Installation And Maintenance Instructions Manual page 10

Commissioning
3 In the absence of other temperatures being specified, we recommend the outlet temperature
quoted in Table 1 are used.
Wash Hand Basin
4 Each basin tap must be commissioned taking into consideration any fluctuations, which
may occur within the system due to simultaneous demands. It is advisable that any outlets
which are connected to the same supply as the basin tap are opened during the setting
of the mixed water temperature. During commissioning it is advisable to ensure that the
water temperatures are established before any attempt to commission.
5 Once the supply temperatures are stable and the normal operating conditions are
established, the tap can be commissioned. The temperature setting can be adjusted
following the procedure described earlier in the Temperature Setting section.
We suggest that the following sequence is followed when commissioning the valve:
5.1 Set the mixed water temperature to the required temperature.
5.2 Measure and record the temperature of the hot and cold water supplies at the
connection to the tap.
5.3 Measure and record the temperature of the water discharging from the basin tap.
5.4 Isolate the cold water supply to the tap and monitor the mixed water temperature.
5.5 Measure and record the maximum mixed water temperature and the final temperature.
The final temperature found during the test should not exceed the value quoted in
Table 2.
5.6 Record all the equipment used during the commissioning.
Wash Hand Basin
6 Ensure that the application, in which the basin tap will be used, is appropriate for the
approved designation. The above information must be recorded and updated on every
occasion when any work is carried out on the bath filler.
© Intatec Ltd 2013
Application
Application
Table 1
Recommended Set Mixed Water Temp.
Table 2
Maximum Set Mixed Water Temp.
9
41˚C
43˚C