Function Selection (P052); Factory Setting (P052 = 1) (Parameter Reset) - Siemens SIMOVERT MASTERDRIVES 6SE7087-6CX86-2BA1 Manual

Parameterization
11.2.1

Function selection (P052)

Precondition
11.2.2

Factory setting (P052 = 1) (Parameter reset)

Function
Condition
Result
P052 = 1
P
11-6
Start-up functions are selected via parameter P052. These provide
start-up variants specially adapted to start-up mode.
Access stage 2 (P051 = 2) must be enabled and the AFE infeed must
not be set to OPERATION (014).
The following functions are available:
♦ Return from function selection
♦ Factory setting
♦ Initialization
♦ Download
♦ Hardware configuration
♦ Closed-loop control setting
♦ Forming
The "Factory setting" and "Forming" functions are reset automatically
on completion, i.e. P052 = 0 (return)!
All other functions must be reset manually.
This function resets all parameters (see Section "Parameter List") to
their factory values (supplied defaults). Please note the setting of P077!
The "Factory setting" function can be selected in operating states
CONTROL SETTINGS (005), FAULT (007), STARTING LOCKOUT
(008) or READY FOR ON (009).
This function sets some converter data according to the device type
(dependent on MLFB / P070).
Select factory setting (Parameter reset)
The numbers of the newly set parameters are displayed
consecutively:
♦ All parameters set to factory values acc. to Parameter List
(even board configuration P090/P091)
♦ Device data (derived from MLFB of converter (P070))
P071 Rated supply voltage
P072 AFE current (n)
P078 Line frequency (n)
♦ Open-loop/closed-loop control parameters
P173 Imax (maximum current)
When the parameter have been set to their factory values, status
display STARTING LOCKOUT (008) or READY FOR ON (009)
appears.
(P052 = 0)
(P052 = 1)
(P052 = 2)
(P052 = 3)
(P052 = 4)
(P052 = 5)
(P052 = 20)
6SE7087-6CX86-2BA1
Operating Instructions SIMOVERT MASTERDRIVES AFE
06.2005
Siemens AG