Lp Gas Cylinder Connection - DCS BH1-48RI Installation Manual

Before connecting the grill to the LP cylinder, the main valve on the cylinder must be
completely closed. Check that all grill burners and rotisserie valves are OFF and open grill
hood.
No signs of damage
1/2" ID flex hose
with 1/2" NPT
fittings
Adaptor 3/8" flare fitting
1/2" NPT female

LP GAS CYLINDER CONNECTION

Signs of damage
Cabinet wall
1/2" NPT fixed
pipe
1. Before connecting to the
new cylinder, check the rubber
O-ring. Do not use new cylinder
if O-ring is worn or damaged.
2. If O-ring is in good condition,
connect the grill regulator to
the gas cylinder valve and turn
gas on.
Turn the burner dials on the
unit to the HI position for about
20 seconds to release air.
Turn the dials off and wait five
minutes before igniting the
burners.
3. If the cylinder is in a
separate cabinet, the installer
must protect the piping for a
distance of at least 2" (50mm)
either side of the enclosure
opening. An LP cylinder
restraint must be installed prior
to use (not supplied).
Gas piping and connectors
must be clamped within the
enclosure to avoid contact with
moving parts and hot surfaces
(parts are not supplied).
27