DCS BH1-48RI Installation Manual page 10

LP Cylinder Hazards
Installation must conform with local codes or with the National Fuel Gas Code ANSI
z
Z223.1 or the CSA-B149.2 Propane Installation Code.
This appliance can be used with any brand of 20 lb LP gas cylinder provided it is
z
compatible with a proper retention device (not supplied for built-in installations).
The LP gas cylinder must be:
z
Designed for use with a Type 1 system only.
z
Constructed and marked in accordance with the Specifications for LP gas
z
Cylinders of the U.S. Department of Transportation (D.O.T.) or the Standard
for Cylinders, Spheres and Tubes for Transportation of Dangerous Goods and
Commission, CAN/CSA-B339.
Provided with a listed overfilling prevention device.
z
Provided with a cylinder connection device compatible with the connection for
z
outdoor cooking gas appliances.
The cylinder must be provided with a shut-off valve terminating in an LP gas supply
z
cylinder valve outlet specified, as applicable, for connection Type 1.
Do not store a full cylinder in direct sunlight.
z
Never use a cylinder with a damaged valve. Always check for leaks after every
z
combustible gas cylinder change.
The cylinder that is used must have a collar to protect the cylinder valve.
z
If you intend to operate your built-in grill on LP gas utilizing a 20 lb Type 1 cylinder, an
z
installer supplied built-in LP cylinder restraint must be installed prior to initial use of
the grill.
Gas piping and connectors must be clamped within the enclosure to avoid contact with
z
moving parts and hot surfaces. Where the gas piping passes through an opening in the
enclosure, the piping must be protected for a distance of at least 2" (50 mm) either
side of the opening.
Connection: LP gas hose with a Type 1 quick disconnect and regulator is included.
z
Operating pressure: 11.0" W.C.
z
All gas piping and connectors must conform to the Standard for Connectors for
z
Outdoor Gas Appliances and Manufactured Homes, ANSI Z21.75/CSA 6.27.
If the appliance is stored indoors, the cylinder must be disconnected and removed from
z
the appliance.
Grills orificed for use with combustible gas come equipped with a high-capacity hose/
z
regulator assembly for connection to a standard 20 lb. combustible gas cylinder (Type
1). The combustible gas cylinder is not included.
Do not use the grill until all connections have been checked and do not leak.
z
If you own or use a spare cylinder, or have a disconnected cylinder, you should
z
NEVER store it near or under the grill unit or heat box, or near any other ignition or
heat source.
Never fill the cylinder beyond 80% full.
z
If the information above is not followed exactly, a fire causing death or serious injury
z
could occur.
10
SAFETY AND WARNINGS