Table of Contents
Advertisement
iSBC® 608/618 MODULAR CARDCAGE & BACKPLANE
Table 2-3.
Compatible Fans
VENDOR
PART NUMBER
Rotron
SU2A1 - 028267
Torin
TA300 - A30473-10
»
Pamotor
8506D
2-10
STACKING INSTRUCTIONS
The following hardware is required for stacking one iSBC 618 expansion
cardcage on a n existing iSBC 608 base cardcage (this hardware is included
with the iSBC 608 cardcage):
Four 8-32 Screws and Kep Nuts
The following steps outline the stacking procedure:
WARNING
Always remove power from the cardcage and backplane before
removing or installing a n expansion cardcage.
Failure to
observe this precaution may result in damage to your equpment
and may impose an electrical shock hazard on your personnel.
a.
Remove power from iSBC 608 cardcage (base unit).
Unplug power
supply from AC outlet if possible.
b.
Remove I/O edge connectors from iSBC boards, and remove all iSBC
boards from the cardcage.
Make a note of which slot each board
occupies (for proper re-installation and priority).
c.
Place the iSBC 618 expansion cardcage on the base unit so that
the expansion connector interface is properly seated.
d.
Install the four 8-32 screws as shown in Figure 2-3, and tighten.
e.
Remove the jumper between post 23 - 24 on the iSBC 608 backplane
to enable the 16 slot parallel priority resolution.
f .
Reconfigure backplane priority
jumpers to obtain desired
slot
priority order.
Refer to Section 2-11 for jumper identification.
g.
Install or move any auxiliary connectors required for your ap-
plication.
h .
Install rack mount rails, if required.
Rails should be installed
to the open end of each cardcage.
10 -
Advertisement
Table of Contents
