•
Loosen the nut bolt using the 21mm spanner
and remove the Hub mounting shank.
Jib Section Assembly
•
Insert the 2nd section into the 1st section
and mount them on the Hub mounting by
aligning the threads.
•
Insert Shank into the Hub mounting ensuring
the holes of the both sections are aligned
with the holes of the Hub mounting.
•
Now, re-insert the washer and nut bolt into
the Shank of the hub mounting.
•
Tighten the nut bolt using the 21mm Spanner.
•
Remove the black shank knob and plastic
washer by loosening them.
12