Perkins 2806A-E18TA Operation And Maintenance Manual page 97

SEBU9074-06
Illustration 61
Typical example
5. Ensure that the oil filter housing (4) is clean and
free from dirt. Install the new filter element (2) into
the oil filter housing (4). To insure correct
orientation of the oil filter element (2), the molding
(6) on filter element (2) must be installed into
molding (7) in the oil filter housing (4).
6. Install a new oil ring seal (3) on to the oil filter
housing (4) and lubricate the O ring (3) with clean
engine oil.
7. Install oil filter assembly (4) into filter base (1) and
tighten to a torque of 80 N·m (59 lb ft).
2806D Replace the Oil Filters
1. Remove the oil filters with a suitable tool.
g06095752 Illustration 62
2. Clean sealing surfaces (1).
3. Apply clean engine oil to O ring seals (2) for the
new oil filters (3).
Do not fill the oil filters with oil before installing. This
oil would not be filtered and could be contaminated.
Contaminated oil can cause accelerated wear to en-
gine components.
4. Install the new oil filters (3). Spin on the oil filter
until the O rings contacts the sealing surfaces (2).
Then rotate the oil filters one full turn. Remove the
container and disposal of the waste oil in
accordance with local regulations.
Fill the Oil Pan
1. Remove the oil filler cap. Refer to Operation and
Maintenance Manual, "Fluid Recommendations"
for more information on suitable oils. Fill the oil
pan with the correct amount of new engine
lubricating oil. Refer to Operation and
Maintenance Manual, "Refill Capacities" for more
information on refill capacities.
2. Start the engine and run the engine for 2 minutes.
Perform this procedure to ensure that the
lubrication system has oil and that the oil filters are
filled. Inspect the oil filters for oil leaks.
3. Stop the engine and allow the oil to drain back to
the oil pan for a minimum of 10 minutes.
Maintenance Section
Engine Oil and Filter - Change
g03860982
NOTICE
97