Perkins 2806A-E18TA Operation And Maintenance Manual page 82

82
Maintenance Section
Coolant (ELC) - Change
1. Fill the cooling system with coolant/antifreeze.
Refer to Operation and Maintenance Manual,
"Fluid Recommendations" for more information on
cooling system specifications. Do not install the
cooling system filler cap.
2. Start and run the engine at low idle. Increase the
engine rpm to 1500 rpm. Run the engine at high
idle for 1 minute in order to purge the air from the
cavities of the engine block. Stop the engine.
3. Check the coolant level. Maintain the coolant level
within 13 mm (0.5 inch) below the bottom of the
pipe for filling. Maintain the coolant level within
13 mm (0.5 inch) to the proper level on the sight
glass.
4. Clean the cooling system filler cap. Inspect the
gasket that is on the cooling system filler cap. If
the gasket that is on the cooling system filler cap is
damaged, discard the old filler cap and install a
new filler cap. If the gasket that is on the cooling
system filler cap is not damaged, perform a
pressure test. The correct pressure for the cooling
system filler cap is stamped on the face of the
cooling system filler cap. If the cooling system filler
cap does not retain the correct pressure, install a
new cooling system filler cap.
5. Start the engine. Inspect the cooling system for
leaks and for proper operating temperature.
Coolant (ELC) - Change
Clean the cooling system and flush the cooling
system before the recommended maintenance
interval if the following conditions exist:
• The engine overheats frequently.
• Foaming is observed.
• The oil has entered the cooling system and the
coolant is contaminated.
• The fuel has entered the cooling system and the
coolant is contaminated.
Note: When the cooling system is cleaned, only
clean water is needed when the ELC is drained and
replaced.
Note: Inspect the water pump and the water
temperature regulator after the cooling system has
been drained.
Illustration 46
Typical example
Drain
i10085293
Pressurized System: Hot coolant can cause seri-
ous burns. To open the cooling system filler cap,
stop the engine and wait until the cooling system
components are cool. Loosen the cooling system
pressure cap slowly in order to relieve the
pressure.
1. Stop the engine and allow the engine to cool.
Loosen the cooling system filler cap slowly to
relieve any pressure. Remove the cooling system
filler cap.
2. Open the cooling system drain valve.
Allow the coolant to drain.
Flush
1. Flush the cooling system with clean water to
remove any debris.
2. Close the drain valve.
SEBU9074-06
g02351659