Perkins 2806A-E18TA Operation And Maintenance Manual page 84

84
Maintenance Section
Coolant Temperature Regulator - Replace
Illustration 48
Typical filler cap gaskets
3. Clean the cooling system filler cap and check the
condition of the filler cap gaskets. Replace the
cooling system filler cap if the filler cap gaskets are
damaged. Reinstall the cooling system filler cap.
4. Inspect the cooling system for leaks.
Coolant Temperature
Regulator - Replace
Replace the water temperature regulator before the
water temperature regulator fails. Replacing the
water temperature regulator reduces the chances for
unscheduled downtime.
A water temperature regulator that fails in a partially
opened position can cause overheating or
overcooling of the engine.
A water temperature regulator that fails in the open
position will cause the engine operating temperature
to be too low during partial load operation. Low
engine operating temperatures during partial loads
could cause an excessive carbon buildup inside the
cylinders. This excessive carbon buildup could result
in an accelerated wear of the piston rings and wear of
the cylinder liner.
A water temperature regulator that fails in the closed
position can cause excessive overheating. Excessive
overheating could result in cracking of the cylinder
head or piston seizure problems.
Failure to replace the water temperature regulator on
a regularly scheduled basis could cause severe en-
gine damage.
Perkins engines incorporate a shunt design cooling
system and require operating the engine with a water
temperature regulator installed.
If the water temperature regulator is installed incor-
rectly, the engine may overheat, causing cylinder
head damage. Ensure that the new water tempera-
ture regulator is installed in the original position. En-
sure that the water temperature regulator vent hole is
open.
Do not use liquid gasket material on the gasket or cyl-
g00103639
inder head surface.
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting, and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
i06223869
Dispose of all fluids according to local regulations
and mandates.
Note: If replacing only the water temperature
regulator, only drain the coolant to a level that is
below the water temperature regulator housing.
Refer to Disassembly and Assembly, "Water
Temperature Regulator - Remove and Install" for the
replacement procedure.
Cooling System Supplemental
Coolant Additive (SCA) - Test/
Add
Cooling system coolant additive contains alkali.
To help prevent personal injury, avoid contact
with the skin and the eyes. Do not drink cooling
system coolant additive.
SEBU9074-06
NOTICE
NOTICE
i03644948