Table of Contents
Advertisement
Safety
3.4.2
Use of qualified personnel
The products may only be assembled, installed, programmed, commissioned, operated,
maintained and decommissioned by persons who are competent to do so.
A competent person is a qualified and knowledgeable person who, because of their train-
ing, experience and current professional activity, has the specialist knowledge required. In
order to inspect, assess and handle products, devices, systems, plant and machinery, this
person must be familiar with the state of the art and the applicable national, European and
international laws, directives and standards.
It is the company's responsibility only to employ personnel who
}
Are familiar with the basic regulations concerning health and safety / accident prevention,
}
Have read and understood the information provided in the section entitled Safety
}
Have a good knowledge of the generic and specialist standards applicable to the specific
application.
3.4.3
Warranty and liability
All claims to warranty and liability will be rendered invalid if
}
The product was used contrary to the purpose for which it is intended,
}
Damage can be attributed to not having followed the guidelines in the manual,
}
Operating personnel are not suitably qualified,
}
Any type of modification has been made (e.g. exchanging components on the PCB
boards, soldering work etc.).
3.4.4
Disposal
}
In safety-related applications, please comply with the mission time T
characteristic data.
}
When decommissioning, please comply with local regulations regarding the disposal of
electronic devices (e.g. Electrical and Electronic Equipment Act).
3.4.5
For your safety
The unit meets all the necessary conditions for safe operation. However, you should always
ensure that the following safety requirements are met:
}
This operating manual only describes the basic functions of the unit. Advanced functions
are described in the online help for the PNOZmulti Configurator, in the "PNOZmulti Com-
munication Interfaces" document and in "PNOZmulti Special Applications". Only use
these functions once you have read and understood the documentation.
}
Please note the "PNOZmulti Installation Manual".
}
You must note the information stated in the "PNOZmulti Safety Manual".
}
Adequate protection circuit must be provided for all inductive consumers.
}
Do not open the housing or make any unauthorised modifications.
}
Please make sure you shut down the supply voltage when performing maintenance work
(e.g. exchanging contactors).
Operating Manual PNOZ m B0.1
1005720-EN-04
in the safety-related
M
| 12
Advertisement
Table of Contents
