Operator Setup Via The Control Board - Assa Abloy NORTON RIXSON 6000 Series Programming Instructions Manual

6000 Series Programming Instructions

Operator Setup via the Control Board

After the operator has been successfully
installed and power has been applied
(refer to Initial Wiring on page 4),
follow the steps below to setup the
operator via the Control Board.
A. Select Arm Type:
1. On the Door Setup REQUIRED menu,
select "GO" by pushing the joystick to
the right. (Figure 4)
2. Move the joystick to the RIGHT or
LEFT and select PUSH or PULL to
set the arm type, depending on the
application. (Figure 5)
NOTE: If unsure, refer to the installation
documents provided with the product
to determine application type.
B. Select Operator Model:
1. After the arm type has been selected,
push the joystick UP to select the
operator model. (Figure 6)
2. Select the specific operator model by
pushing the joystick to the LEFT or
RIGHT.
PULL (Figure 7)
‒ 6011 PULL 110°
‒ 6051 PULL 110°
PUSH
(Figure 8 or Figure 9)
‒ 6021 PUSH 110°
‒ 6031 PUSH 110°
‒ 6061 PUSH 85°
‒ 6061 PUSH 90°
‒ 6061 PUSH 95°
‒ 6061 PUSH 100°
‒ 6061 PUSH 105°
‒ 6061 PUSH 110°
‒ 6071 PUSH 85°
‒ 6071 PUSH 90°
‒ 6071 PUSH 95°
‒ 6071 PUSH 100°
‒ 6071 PUSH 105°
‒ 6071 PUSH 110°
3. Once the specific operator has been
selected, push the joystick UP.
Copyright © 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1043-020 Rev 2 10/23
Door Setup
REQUIRED
Figure 4
Figure 6
PULL: 6011 or 6051
Figure 7
PUSH: 6021 or 6031
Figure 8
PUSH: 6061 or 6071
Figure 9
GO
Figure 5
PULL:
6011 PULL 110°
Door Mode
PULL
5